Page MenuHomeVyOS Platform

Configs not saving
Closed, ResolvedPublicBUG


I just did a fresh installation of 1.2.0 RC10 on a Zotac nano. Installation used all default options, and no error messages seen.

I then rebooted the box, changed the config (changed IP addresses on Ethernet interfaces), did a commit and save (all with no error messages). I rebooted again, but all of my configuration changes were gone (Note: the password set for user vyos, during the installation was saved).

Multiple attempts and multiple reboots - all the same.

I then did a fresh install of 1.2.0 RC8. Again - same default options, no error messages.
Saving the config works fine!


Difficulty level
Unknown (require assessment)
VyOS 1.2.0 RC10
Why the issue appeared?
Will be filled on close

Event Timeline

ptotten created this task.Dec 6 2018, 3:57 PM
pasik added a subscriber: pasik.Dec 16 2018, 11:16 AM
syncer changed the task status from Open to Needs testing.Jan 3 2019, 2:06 PM
syncer triaged this task as Normal priority.
syncer edited projects, added VyOS 1.3 Equuleus; removed VyOS 1.2 Crux.
syncer added a subscriber: syncer.

Please retest on latest rolling

Viacheslav closed this task as Resolved.Jul 27 2020, 2:47 PM
Viacheslav claimed this task.
Viacheslav added a subscriber: Viacheslav.

I'll mark it as resolved. Reopen it if necessary.

c-po moved this task from Need Triage to Finished on the VyOS 1.3 Equuleus board.Aug 3 2020, 3:33 PM