I have confirmed that this issue is now resolved when building from equuleus. I've attached a screenshot showing the table for the dynamic interface has a default route after the interface get's an IP. I used the following commands to build the ISO.

I don't know what I'm building. How can I be sure I'm actually building 1.3.0 rather than 1.4? I ask because when I boot off the build I compiled I get the following message at the start of the boot process. Is it 1.3.0 or sagitta (1.4)?

Failover is handled by my firewall which is upstream of VyOS which I am using more as a router than anything. The commit you listed I believe is actually the fix for T4206, not for this, but I can certainly try that to see if I'm up and running and to see if the issue I'm reporting here is resolved, since I have only tried this setup in 1.3.0 RC6. I'm not sure why you'd think I'd need " failover with custom hook-scripts" for this issue. All I'm trying to do is have a PBR for traffic with the destination IP of local VyOS interfaces to use the main table rather than the vrf table. I also have an issue where if I ping the IP on the FIOS WAN interface from upstream, the reply traffic from the VyOS is sent downstream to the FiOS gateway, so this fails. However, the VyOS isn't doing that for the WOW! WAN interface, and I get the replies as expected. So it seems there are strange things happening. Either things not being cleaned up and/or not being set up right.